Make: Metlor Model: SL-FT-010 Standard: ASTM D1322, IP 598 The Smoke Point method, in accordance with ASTM D1322, IP 598, is one of the oldest test methods in the petroleum industry. This test method provides an indication of the relative smoke producing properties of kerosenes and aviation turbine fuels in a diffusion flame. The smoke […]
Make: Metlor Model: SL-FT-009 Standard: ASTM D1322 IP 57 The Seta Smoke Point Apparatus determines the smoke point of kerosine and aviation turbine fuel by measuring the maximum flame height prior to smoke formation and comparing the results with those of known standards. The smoke point gives an indication of aromatic content and radiant heat
Make: Metlor Model: SL-FT-008 Standard: AASHTO T48, ASTM D92, BS 2000 Parts 36 & 403 (obs), EN ISO 2592, FTM 791 1103.7, IP 36, JIS K2265, NF T60-118 The Seta Semi-Automatic Cleveland Open Cup flashpoint Tester is equipped with an electrically heated cup (with a variable control to set temperature rise rate), a button-operated and
Make: Metlor Model: SL-FT-007 Standard: IS:1448(P-6) Product Introduction: A Bomb Calorimeter measures the amount of heat generated when matter is burnt in a sealed chamber in an atmosphere of pure Oxygen gas. Bomb Calorimeter provides a simple inexpensive yet accurate method to determine the Heat of Combustion, Calorific Value and the Sulphur contents of solids
Make: Metlor Model: SL-FT-006 Standard: ASTM D93; AASHTO T73-811; IP 34; ISO 2719; DIN 51758; FTM 791-1102; NF M 07-019 Determines flash points of a wide range of products by a closed cup method with two option speed stirring of the sample. Extensively used in shipping and safety regulations for detection of contamination by volatile and
Make: Metlor Model: SL-FT-005 Tar Viscometer Viscosity is the property of the fluid by which it resist flow due to internal friction. Used for determining viscosity of cut – back bitumen and road oil. Viscosity is measured by determining the time taken by 50 cc of the material to flow from a cup through a
Make: Metlor Model: SL-FT-004 Standard: EN 12846 | EN 13357, IP-72 and IS 1206 Used for determining the viscosity of cut-back bitumen and road oil. The apparatus, housed in a stainless steel case, consists of a tank fit with a thermostat, a rheostat, an agitator, an immersion heater to take the water to the required
Make: Metlor Model: SL-FT-003 Standard: IP 33/59 & IS 1448 P :20 The automated Abel flash point tester is used primarily to test flammable and combustible materials for shipping and safety regulations. The flash tester provides an increased temperature range of operation as compared with other testers, allowing greater flexibility in testing samples according to
Make: Metlor Model: SL-FT-002 Standard: IP 70 The simple design of the Redwood viscometer confirms to standard IP 70 requirements while providing accurate measurements for viscosity tests. The stainless steel Redwood viscometer is equipped with digital temperature regulation, over temperature alarm, and an insulated double wall, because operator safety is a priority. A single gage
Say Bolt Viscometer Apparatus Make: Metlor Model: SL-FT-001 Standard: ASTM D88; AASHTO T72 The SL-FT-001 Saybolt Viscometer is used to determine empirical measurement of Saybolt Viscosity of petroleum products at specified temperatures. The time it takes for a 60mL sample to flow through a tube with a specified diameter (furol or universal) is measured and
