MODEL NO-IM-010 DESCRIPTION: The ”Metlor” Trainer provides a comprehensive experimental introduction to the fundamentals of control engineering using an example of level control. A pump delivers water from a storage tank to the transparent level-controlled tank. The liquid level is measured by a pressure transducer installed at the base of the level-controlled tank. The controller used […]
MODEL NO-IM-008 DESCRIPTION: The ”Metlor” Trainer provides a comprehensive experimental introduction to the fundamentals of control engineering using an example of flow control. A pump delivers water from a storage tank through a piping system. The flow rate is measured by an electromagnetic sensor, which permits further processing of the measured value by outputting a standardized
MODEL NO-IM-001 DESCRIPTION: The ”Metlor” Trainer helps to studies Study of a Stroboscope. Measurement of Angular Speed (RPM). The Trainer complete with: DC power supply for application circuit. Reflector fitted with motor shaft. Mini DC motor with speed control arrangement. Strobe signal generator with frequency display. Strobe light Generator arrangement. Strobe light Frequency meter (digital)
MODEL NO- HMT-008 DESCRIPTION: The “Metlor“ heat transfer insulating powder trainer unit consists of two thin wall concentric copper spheres. The inner sphere houses the heating coil. Heating coil is made up of nichrome wire wound on mica sheet. The insulating powder packed between two shells. Power supply to the heater is given through a dimmer
Computerized Thermal Conductivity of insulting Powder Read More »
MODEL NO-TE-021 DESCRIPTION: The “Metlor” experimental bench top unit for studying the air flow measurement and airflow characteristics in optional apparatus. The set uses an industrial type centrifugal blower with inlet and outlet ducts, flow straighteners, a damper, various flow measuring devices using manometers for the study of air flow measurement according to BS 848 and
MODEL NO-TE-012 DESCRIPTION The “Metlor” experimental test stand, which includes a drive and brake unit, the four-stroke diesel engine is highly suitable for use in teaching the fundamentals of engine functioning and measurement. The engine used here is an air-cooled single-cylinder four-stroke diesel engine with direct injection. The diesel engine is started and slowed down
Single Cylinder Four Stroke Diesel Engine Test Bench Read More »
Model NO- TM-009 DESCRIPTION The “Metlor” designed and developed experimental setup helps to investigate the characteristic behavior of a simple-regulated Kaplan turbine during operation. The trainer is provided with a closed water circuit with tank, submersible pump and throttle valve for adjusting the flow rate. The angle of attack of the rotor, and thus the
Model NO- TM-006 DESCRIPTION The “ Metlor” ” designed and developed gear pump is the most widely used of the positive action rotary pumps. Two gear wheels operate inside a casing. One is driven while the other rotates in mesh with it. The liquid is carried around in the space between consecutive teeth and then
Model No-FM-019 DESCRIPTION: The” METLORINDIA” module consists of a quadrant assembled to the arm of a scale that swings around an axis. When the quadrant is immersed in the water tank, the force that acts on the flat rectangular front surface exerts a momentum with respect to the supporting axis. The swinging arm is fitted with
Model No- FM-014 DESCRIPTIONS: The”METLORINDIA” hydrostatics bench, numerous experiments on the topic of the hydrostatics of liquids and gases can be carried out. A pipe section and various pressure measuring devices are fitted to a laboratory trolley with a demonstration panel, working area and cabinet. Various measuring containers are integrated into the pipe section. The
